Shearing Machines - Hydraulic Sharing Machines

FRAME :
Rigid steel frame of "ATLAS" shears are optimally designed to avoid weak sections at load support and is of interlocked design. The table of frame is welded together with support of steel plates. The table top surface is machined with provision of t-slot to facilitate front gauge stopper. Ram assembly is welded with steel plate support.

RAKE ANGLE (VARIABLE) :
Rake angle selector switch is provided in control panel to vary the rake angle. It permits to shear higher thickness than its capacity. Thin sheet can be cut w/o distortion.

ROLLER GUIDES :
The upper beam is guided by three point roller guides. A replaceable hardened Liner is provided for minimum wear. It eliminates lubrication of guides.

HYDR. POWER PACK :
Hydraulic system is mounted at top at rear side of machine. Hydraulic components are of internationally reputed make like Vickers, Dowty, Rexroth, etc. Valves are mounted on a compact manifold block minimizing piping and chances of leakages. For oil cooling sufficient size of oil reservoir is provided.

CYLINDERS : Cylinders are recisely honed and are fitted with hard chromed piston rod with best quality sealing elements. Cylinders are connected with upper beam (cutting beam) with spherical bearings for higher capacity. Two cylinders are working on differential pressure principle for synchronization. This eliminates force on cutting edge.

HYDR. HOLD DOWN :
Hydraulic hold down pads hold the sheet secarely to avoid slipping & bowing resulting in clean square cut. Hold down units are provided for better clamping while cutting narrow strips.

BLADE CLEARANCE :
Blade clearance can be adjusted manually by lever on each side of machine with calibration of clearance suitable for thickness.

MOTORISED BACK GAUGE :
Motorised back gauge is operated from front of machine by push button. Back gauge traveled distance is displayed on electronic counter. Next position can be preset and can run with auto stop arrangement. Back gauge automatically retract from bottom blade after Shearing, to avoid trapping of cut strips.

BLADES :
ATLAS shears are provided with high quality, Single segment (HcHcr) blades for longer tool life. Ease in assembly of blade reduces down time. The blades are four edged.

OPERATION :
Electric panel & operational console are provided at right side of the machine for easy operation by operator. Console & control panel is provided with on-off push-button, three phase indicator forward-reverse push-button for back gauge operation, inch push-button for individual hold down function emergency stop push-button. Foot switch is provided to carry out Shearing Operation if foot switch is released at any point of shearing upper beam will return from that point.

FINGER GUARD :
Fitted in front of hold down for operator's protection without obstructing viewing.